**** Welding hack-using Tile levelers

[NYBODYMAN]

**Disclaimer-I haven't tried this yet**
I saw this on an auto body Facebook page and seems like it would work well. These levelers are cheap on Amazon.com so I bought a bunch. I plan to use them when I install the new floor pan in my Fox Body SSP Mustang.

https://www.amazon.com/Leveling-Leveler-Special-Wrenches-Spacers/dp/B08L54NF4G/?tag=atomicindus08-20

 

[dogdog]

They sell these specifically for sheet metal welding. Not sure the advantage of plastic other than cheap. Hf have these also probably cheaper.

https://www.amazon.com/dp/B08SR3HBVZ?tag=atomicindus08-20

 

[NYBODYMAN]

Yes I have those as well. I probably should have elaborated a bit. These are good for areas where you can't get to the back of the panel to remove the clamp as is necessary with the **** welding panel clamps you posted.

 

[The Cobbler]

good idea . thanks for sharing the idea

 

[Sumboodie]

Magnet

 

[NYBODYMAN]

Magnet

Yes a magnet works as well but there could always be areas where some pressure is needed from the back to fine tune the fitment.

 

[PugetDude]

Ordered a 50 piece pack to try. Only $7.99
Thanks!