Wera kraftform plus chisel driver vs witte pro impact
- Thread starter ive
- Start date
Machinehead
Well-known member
- Joined
- Jan 10, 2025
- Messages
- 60
I have the Wera chisel driver and they exceed their expectations. I've taken a 3lb sledge to the #2ph a beat the living snot of it and performs like new and looks like new. Why I was doing that is another story. They are also black and yellow "Steeler" color so they are even better. I'd vote Wera.
Nobody-named-Olli
Well-known member
Among those two options: Wera Kraftform plus. Why? My main supplier stocks the Wera Kraftform plus series and because of sale volume prices them very competitively. Generally, I have no bad things to say about them, they work, they wear, they get replaced by me when necessary.
The Witte I would have to special order, or buy from another vendor. None of my frequently used (industrial) suppliers sell Witte outright (or, to the best of my knowledge, use Witte as manufacturer for their branded/private label stuff.)
And then, if I did go the extra mile of a ‘special order’, which I sometimes do when not time sensitive, I would always get the PB Swiss demolition drivers because I ultimately like them best. But that was not the question.
Kind regards,
Olli
The Witte I would have to special order, or buy from another vendor. None of my frequently used (industrial) suppliers sell Witte outright (or, to the best of my knowledge, use Witte as manufacturer for their branded/private label stuff.)
And then, if I did go the extra mile of a ‘special order’, which I sometimes do when not time sensitive, I would always get the PB Swiss demolition drivers because I ultimately like them best. But that was not the question.
Kind regards,
Olli
Last edited: