To avoid these ads, REGISTER NOW!

What are these?

Runs With Scissors

Active member
Joined
Mar 23, 2006
Messages
25
Location
Tulsa
Coulda swore I posted this yesterday but????????



Anywa, I need to know what these are...

DSC00005.jpg



They are in my foot high stem wall about 18" apart, all the way around the shop.


I'm guessing they were used to hold the form but they are still here and in the way.

Can I cut them off or are thy doing something I'm unaware of?

Thanks!
 
To avoid these ads, REGISTER NOW!

mikeyr

Well-known member
Joined
Sep 16, 2005
Messages
1,971
Location
Santa Barbara, CA
looks to me like your garage/shop was built by a car guy who needed anchoring points to move heavy stuff. I have something similar at the end of the wall so I can hook up a come-along and winch a non-running car into the garage.
 

dv8

Active member
Joined
Apr 3, 2006
Messages
35
Location
Riverview, FL
Those are restraining loops for hooking up a "Gimp". I've got a few in my shop...but you allready knew that.
 

GearHead_1

Well-known member
Joined
Jan 9, 2005
Messages
544
Location
Utah
They are the links that hold the concrete forms together when pouring the foundation. Just put a screwdriver in the loop and turn it about 90 degrees. It will pop off slick as can be. They aren't made to stay there someone just hasn't taken the time to clean up.
 
OP
R

Runs With Scissors

Active member
Joined
Mar 23, 2006
Messages
25
Location
Tulsa
Thanks! The outside looks like they were there too but I don't know anything about foundations except that my shop is built on a hill and I'd really prefer it stays there!

I was afraid it was some post tensioning **** or???

And DV8, these things look much more sturdy than the things I pulled out of the floo in your shop....


Thes things are right square in the way of building some shelves with backing on them.
 

bobbyd

Well-known member
Joined
Mar 17, 2006
Messages
137
Location
Kansas
I'm suprised to see a residential type builder using snap ties or loop ties to begin with. Typically they use wire ties, which are a big pain in the ****, have sharp ends and leave a ridge of concrete around where they poke through the forms. They must use a modular form system like Simons or Gates forms instead of the typical plywood panel forms.
 
To avoid these ads, REGISTER NOW!

LS6 Tommy

Well-known member
Joined
Dec 27, 2013
Messages
26,162
Location
Northern NJ
To avoid these ads, REGISTER NOW!
Top Bottom