pendragon1998
Well-known member
Please, justify my hot deals-related financial implosion...What have you pried lately with your (on sale for $19.99) Craftsman pry bar set?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
What have you pried lately?
- Thread starter pendragon1998
- Start date
shocksandstrutz
Well-known member
two weeks ago i had to use my recently purchased set of CMAN prybars to pry out the front lower control arm on my BIL's car. thing was stuck and didnt just come loose. then had to use it again when i was putting it back on to align the ball joint and the spindle.
also used it on the same car replacing the cv joint (axle) on the drivers side. just gave it a quick push and the axle slide right out.
great set for 20 bucks
also used it on the same car replacing the cv joint (axle) on the drivers side. just gave it a quick push and the axle slide right out.
great set for 20 bucks
sberry
Banned
Hard to go wrong for 20$.
dirtmister16
Banned
calipers. today, yesterday. before that. prybar for moving a engine on a stand,out of truck ect. i could use it for a door stop, but i have a gaint screw for that.
shockwave
Well-known member
Not bad at all 20 bucks for a set they work well on belts for Toyota v6 too
Coach James
Well-known member
Recently: calipers, porch hand rails, weightlifting platform, pommel horse, vaulting table, desk drawer, cover for the street water shut off.
Coach
Coach
gahrajmahal
Well-known member
Don't know what the c'man set looks like, but I used the smallest one (6") in my set, to pry the plastic caps off the battery in my truck to check the water level.