What I did for drawer mat and welding carts

[gball]

So i decided to use the precut rolls of this stuff from Home Depot. Think it was 27" x 6' or close to that. Think it was more like 27 1/2''. A roll was just over $12. I tapped the end of the roll on bench to square it up and cut the length of the roll to the depth of my drawers (deepest drawer) using 10" miter box with a fine panel blade. Then unrolled and used carpenters square to straighten out the end (none of the rolls were square). Marked lengths of drawers and used a utility knife and square to cut. Started with bigger drawers then used cut offs for smaller top drawers and welding carts. Now i'm looking around for other stuff to line. Would probably be a easier job if it wasn't 10 deg. too.

 

[southalabama]

Looks good

 

[gball]

Thanks. Slowly getting things in order here. Still don't have all the drywall hung or finished so the more i bring in is just more i will have to move again. Plus i have the mess of siding and other building materials in the way... and the babys toys.

Two boxes down, Two more to go.


Mess this way.


..and Mess that way.