What’sit?

[dffay]

Fine knurling with two internal dimensions: 1.0 inch ID and .85 on the other side.

Internally it is stamped SNAP-ON TK-20.

Google isn’t very helpful.

 

[Old Man Roger]

Sure you got the TK-20 right? Google image search says that’s not a snap on #

Subsequently I suspect it isnt a saw set.

 

[dffay]

Definately Snap-On. Might predate the latest numbering system and its small enough to not have enough room for a lengthy code.

 

[Johnny chaos]

google lens says fork seal driver? It does sort of look correct?

 

[Old Man Roger]

Too small for any forks I’ve ever worked on. And there wouldn’t need to be a smaller diameter towards the middle.

 

[senlow]

In the past, Snap-on used the TK prefix on part numbers for torque adaptors. In the dim and distant past, TK was used on distributor tools.

 

[dffay]

Another view.

 

[dffay]

Nice piece off machining. Ferrous metal.

 

[dffay]

My only other guess is that it’s part of a set with larger and smaller ones. So the big part number is truncated per piece.

 

[Old Man Roger]

Is it threaded inside? If it is it might be part of a puller for motorcycle stators.

 

[loganb]

AI(Claude) wasn't of much help and was suggesting some sort of ignition service tool or part of some type of set for seals etc. It did actually cite this very thread though which I thought was more interesting

 

[senlow]

AI(Claude) wasn't of much help and was suggesting some sort of ignition service tool or part of some type of set for seals etc. It did actually cite this very thread though which I thought was more interesting

Sometimes I think that the AI's name should be Clod.

 

[dffay]

Smooth inside. Something used to gather needle or ball bearings to place over a shaft?
I’m stumped.