When to add the anti slip?

[SCutchins]

I have a 3-car garage, about 610 square feet, and have decided to use the EpoxyGuard 100% solids kit from CostCo for the floor. Great kit, comes with roller, squeegee, even gloves and goggles. It also comes with paint flecks and non-slip additive. I needed two kits, each does about 480 square feet at 10 mils, for a total of $500 to my door.

The instructions say to scatter the paint flecks "like rain" immediately after squeegeeing and rolling, but when do you apply the non-slip additive?

I'm not sure if you throw it on at the end or if you mix it in with the epoxy when mixing parts A and B.

 

[MDoneday]

Do the same as you do with the paint flecks, or at least that is what I did with my Epoxy-coat application. Worked great. I tossed the non-slip against the ceiling to give random pattern.

 

[SimpleManLance]

toss it up like the flakes, then back roll over it.

 

[nissan_crawler]

I did one coat, tossed the additive on top (I didn't use much), then covered it with the next coat.

 

[Matti]

If it's the same as the Rustoleum stuff you mix it in before rolling. I did find that alot of it stayed at the bottom of the paint tray though. The floor still has a ton of grip. The Rustoleum stuff is fine aluminum oxide grit.