WIHA Terminator Bits - Recent Quality ?

[mobiledynamics]

My driver bits is a mix or Robertson (Canadian made), using up a bunch of Apex 1/4 bits, and bunch of impact Wiha Terminator Torx, Vessel Impact PH and a few Wera Impact Sets..

I am pretty much complete Except I need to add a PH3 to my stash

I see Wiha's Terminator is going really inexpensive these days and there is Terminator Blue.
What's the scoop with the Terminator Blue Series
Anyone buy any Wiha Terminator Bits of any sorts lately ?

Heck, I'm inclined to just buy a Makita XPS bit set as it's so dang cheap

 

[pizza]

bumping because i'm curious, too. what's going on with wiha terminator?

they used to be these **** looking bits with good surface finish and translucent red plastic bling, and now they look like ****. maybe that is an overstatement, but i think we can all agree the new ones aren't as ****.

idk, i say just grab a pbswiss PH3. lol

 

[AEAdam]

I haven’t tried the ”premium” bits outside of apex. My experience has been that some manufacturers’ bits fit some PH2 or PH3 better than others. Not so with torx or Robertson, and I’m not confusing pozis.

So far, I’ve found the dewalt bits to be terrible, apex don’t always fit. I tried the milwaukee Phillips that are “necked” like torque sticks. I was very skeptical, but they do seem to work.