Wire clips?

[Coolerman]

I am finishing the alarm install in my shop. The shop is a steel building with the girts running around the perimeter at about 4'. These girts are thin metal and I am looking for some wire clips to hold the very small 4 conductor alarm cable to the inside of the girts to hide it. The guys that installed my garage door used these small plastic clips to hold the wires for the sensors and door switch to the girts. I called them and they didn't know where they had gotten them. I have searched using several different terms but can't find exactly what I am looking for.

Anyone have an idea of whom might carry such things? I need about 100 to do the job.

 

[gayler]

Dang why are these so hard to find? It took me half hour to find these. Are these what you're looking for? http://www.ebay.com/itm/like/110933025265?lpid=82

 

[Coolerman]

Thanks for that link it gave me some other search terms! Those would work, but at $0.85 each I would have more in clips than I do in the entire alarm system including wire!

I have been looking for two days off and on. I found all kinds of adhesive type, screw type and pop in hole types but no "slide over the edge of sheet metal type"

Here is a pic of what I am looking for....

 

[joe_padavano]

These are repros of the clips GM uses to hold small cables onto the edges of body panels and frame rails. Under $10 for a box of 50.

 

[Coolerman]

Found them! Guy on a security site knew exactly who made them (Linear: Part # HAE00019) and a site where I could get a box of 100 for under $20.00! http://www.plccenter.com/Buy/LINEAR SECURITY -AND- CONTROL/HAE00019

So if anyone needs a way to easily add small wires to their metal girts there ya go!