wiring my Binks compressor

[mrmopartech]

I just replaced my 53 year old electric motor on my binks compressor and the company gave me a square D box and a new pressure switch.The main box is a 8911 unit,power comes in the top,out the bottom to the motor,not a problem,pressure switch operate,s magnetic relay to allow power to go through from top to bottom.my electrician can,t seem to get the wiring right to operate the system,need help.I have a small business and its costing me money,if any one has installed one of these,call me asap so I can get this thing going.Give me a call and i call you back on my dime,so we can stop the madness,mrmopartech/St.Lazare Quebec Canada 450 424 0445H 514 659 0445cell,thanks in advance

 

[PT Doc]

Photos would be helpful and then many people could help you.

 

[nehog]

http://www.electriciantalk.com/f28/square-d-mag-starter-trouble-10607/ and read the thread. Also google will provide other references.

Photos, and all the specs from the starter are important. An example, is the coil 120 or 240 volts? There are a number of 'flavors' for the 8911 so the specs on the id or specification plate/box are important.

 

[mrmopartech]

Your system will not allow my pictures to be up loaded,mrmopartech