Work cart update

[TheGrooveking]

Figured I throw a pic up of my work cart, I'll get some of the drawer shots up soon. Still using the KRL1001 as my stationary tool storage. Industrial maintenance is where I use this. I initially went with the 2 bank for the shorter wheelbase so I could manuever it around equipment. I have to still mount the 2" angle iron - 3/8" top plate to/around/over the Matco 3018HSL on the right side. I have a Ridgid 6" vise to mount on the 3/8" plate and some other custom stuff. I'm adding 3 six gallon air tanks underneath so that I can charge them to 200 psi, thus have some air when needed.

TheGrooveking

 

[e30bradley]

Nice!

 

[Matt472]

I'd consider that a little more than a "cart". But nice setup either way.

 

[TheGrooveking]

To me its a cart, as that I roll it out to all of the repairs I work on.

TheGrooveking

 

[jjjrmx5]

LOLZZZ.

That's not a cart in my world.

That's a dual bank roll cab with lots-o-**** hung on it.

If I had to move that around daily and efficiently and still be on an hourly or TAKT time repair or mod schedule I'd be let go within 30 days.

Nice rig though.

 

[Bigplum]

The shavings from the cut off wheel will play havoc with the drawer runners,
I picked up a S/H snap on roll cab that was used in a fabrication workshop ,
poor runners were full of nasty bits , devil of a job clearing them out

 

[gasaxeman]

Does that have a hitch?
Probably a good workout pushing from job to job!

 

[TheGrooveking]

The cut off saw was just being transported from one of my upright black steel cabinets (36"x 24" & 48" x 24"). I would never use the cut off saw on top of that box. This rig rolls effortlessly, the real issue is stopping it once it starts rolling!

TheGrooveking

 

[DodgeMech]

So, if this is your cart, is your box two of those snapon "Mr Big"s welded together?

 

[TheGrooveking]

No right now its a Snap On KRL1001 with a Kennedy 11 drawer machinist chest and a Kennedy 6 drawer mechanics box on top of it and Kennedy 8 drawer 3900MP maintenance pro roller cabinet for most of my machinist tools that I roll up to the mills/lathes.

Later this year/early next year the Snap On will be replaced with a Matco 6s series 6331RX rollaway and a 6331TC top chest to match my cart.

TheGrooveking

 

[ckadams00]

That's Not a Cart. That's a Space station.