I'm redoing an old Bunting slider glider patio loveseat. I have found replacement springs and assorted hardware but replacement rubber feet are all but impossible to find. The feet are rubber and an oddball "T" shaped. Has anyone got any suggestions about what I can use in a wax mold. Flex Seal looks interesting but I have zero experience with it and it's fairly expensive. Any other products to try?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Workable Rubber
- Thread starter Stadger
- Start date
Does it have to be traditional rubber? You can get a poly mix that can be cast at home using your own molds. It's available in various shore A hardness.
Example: http://www.industrialpolymers.com/products/truecast-series
Sent from my Moto G (5) Plus using Tapatalk
Example: http://www.industrialpolymers.com/products/truecast-series
Sent from my Moto G (5) Plus using Tapatalk
Fluxion
Well-known member
Smooth-on.com has several varieties of rubber and urethanes for casting. The sell trial size samples too if that might be enough.
Edited to add: Try this link instead, it's a direct link to their online store. It can be a little inconvenient to get to the store from the link above.
Edited to add: Try this link instead, it's a direct link to their online store. It can be a little inconvenient to get to the store from the link above.
Last edited:
Make them out of hockey pucks?
https://www.garagejournal.com/forum/showthread.php?t=400269&highlight=Hockey
https://www.garagejournal.com/forum/showthread.php?t=400269&highlight=Hockey
Bigblue&Goldie
Well-known member
Sounds odd, but I was able to find the rubber feet I needed for a project from an exercise equipment repair parts place.