Wrench racks for jumbo sized wrenches?

[Ron Swanson]

I have a set of SO wrenches going up to 1 3/4" that are taking up too much room in my box. Does anyone know of a wrench rack that goes up that big?

 

[canuckian]

I have a set of SO wrenches going up to 1 3/4" that are taking up too much room in my box. Does anyone know of a wrench rack that goes up that big?

My metric set goes to 36mm and I e yet to find a rack that'll accommodate them all. I use an ernst rack and a section of the snap on wrench rails. Not pretty but it keeps them in place

 

[scissorman]

I have a set of SO wrenches going up to 1 3/4" that are taking up too much room in my box. Does anyone know of a wrench rack that goes up that big?

I'm in the same boat right now, my current SO wrenches are from 1/4" - 1 1/2" but going all the way to 2" and I would like to have them ALL on the same rail/holder. My problem is twofold as my wrench drawer is only 2.25" height so I already know that some of the larger wrenches will have to just lay flat.

Keep me posted if you find something that works for you. What is the height of your wrench drawer?

 

[FOCUS.FREAK]

Have you checked these out?

http://www.ernstmfg.com/store/c/49-Wrench-Rails.aspx


Edit: problem might be that this only holds 20. I have seen people buy multiple sets and cut them.

 

[scissorman]

Have you checked these out?

http://www.ernstmfg.com/store/c/49-Wrench-Rails.aspx


Edit: problem might be that this only holds 20. I have seen people buy multiple sets and cut them.

I just gave 2 sets of those away on thursday as they just didn't hold the wrenches properly.

 

[Ron Swanson]

I tried the ernst a few years ago and it wont work with the real big wrenches.

 

[AustinG]

I don't have a picture but I'm using a cut up dish rack to store my 1 1/4-2" wrenches it works great.

 

[bobcatdan]

I stand mine up as if they were in a rack aganist the back of the drawer. Then place other tools in front to hold them in place. With the wide beems and heads, they stand up pretty easy. This works just fine for me that I see no point for a rack.

 

[HighPlainsWrencher]

I use the Torin magnetic screwdriver holder SDH15RT.

 

[2ndGearRubber]

Hate to say it, but I use a HF metal rack for the big stuff, Ernst rack for the lower sizes.


It does scratch the chrome going in and out though. The very picky could cut of the stabilizing tabs though, basically give the wrenches a small space to lean, however they wouldn't be secure enough to carry by the handle of the holder.