WrightGrip 1.0 vs 2.0

[Wamsutta]

Do any of you guys have both versions? I have one single WrightGrip 1.0 in the size 1/2 inch that I picked up at a contractor supply.

Nice wrench but the open end is completely unusable unless you can tolerate the constant gritty feel and the grinding noise of it getting caught on the nut as you're trying to pull the wrench away for another turn. How does the 2.0 feel compared to the 1.0 ?

 

[Winterborne]

Edited for clarity:

Recently moved to FACOM 440 after experiencing challenges with the Wright 2.0 and brass fittings. On steel fittings I am neutral about the Wrights.

I included a quote from another member regarding the brass fittings:
>Quote 1/29/2023 Thread

If you get the toothed anti-slip designed wrenches and see yourself working on brass, chrome, or soft metal fasteners then you will definitely need a second set with a smooth open end. My Wright wrenches tend to eat into the softer metals and deform the fasteners especially if I have to put some extra ugga-duggas into it. You can avoid this by getting the Williams Supercombo or any of the SBD brands with the ASD like the Protos. They use notches on the open ends that tend not to badly damage fasteners over time. They don’t work as well as my Wrights but it’s a trade-off. Personally, I keep my Wrights for outdoor use on like the car and lawn stuff and I keep my other wrenches for work and indoor stuff.

 

[KnurledNut]

1/2" wrench? What are you working on? A shopping cart axle nut?
I recommend returning it to the supply house and telling them why its completely unusable.
What were you thinking buying something other than Snap-on, Merk?

 

[American Locomotive]

My 2.0's don't feel gritty. Never used them on something soft though.

 

[Wamsutta]

1/2" wrench? What are you working on? A shopping cart axle nut?
I recommend returning it to the supply house and telling them why its completely unusable.
What were you thinking buying something other than Snap-on, Merk?

For those shopping carts, I was using two extra long 1/2 inch Snap-on's. They be some bad-*** wrenches.

My 1/2 inch Wright 1.0 is heavier than my Snap-on in the equivalent size even though the Wright is one inch shorter.

 

[Hakeem]

I’ve used them on hundreds of brass fittings and the damage inflicted is greatly overstated, IMO. MAYBE you get two lines imprinted on a couple of the flats but nothing to write home about. I wouldn’t use them on a chrome fastener but otherwise they’re fantastic