WTB - 3/16" Ridgid tubing bender

[OldnSlo]

Found....

Found....

 

[Camtwo69]

I just bought one today at the flea market for a buck .

 

[OldnSlo]

Ha, so does that mean I should offer fifty cents for it? I'm guessing this is for sale, then, if so, do PM me a price please.

 

[jabberwoki]

And i got one for .75 at the swap!!!

 

[OldnSlo]

All joking aside, still looking to purchase one!

 

[bofum]

I have a RIGID 396 i beleive it has a 3/8 OD capacity, will this work?

 

[OldnSlo]

@bofum, thanks but it's a bit too big. The larger sizes dont allow for good support on the side of the tubing, thus it crimps. Shown in the pic is my 1/4" and it still crimps. The correct smaller size makes a wonderful supported bend that works flawlessly.

 

[bofum]

O.K.

 

[Dubbydoo]

I think I actually have a few of these 2 of them the handle has been cut and welded and will only do 90 degree bends and i have one that is the 180 degree let me double check the size

 

[OldnSlo]

Found..