WTB: 37 Degree Flaring Tool

[FastKat]

I am looking for a 37* flaring tool to flare some 3/8" mild steel tubing as an alternative to this one here:

http://www.amazon.com/dp/B004FEJF2Q/?tag=atomicindus08-20

PM me with what you have!

 

[OldToolMan]

just dug out my large imperial tool.I don't think it goes that small.

 

[FastKat]

Thanks for checking! Anybody else? I am thinking about buying the cheap tool above but I'm just not sure. There are other designs I like better, but I just don't use it all that often.

 

[FastKat]

Thanks to all that PM'd me with tools. I did some research, and there were people that used the cheaper one (that I linked to above) and had problems with leaky joints.

http://www.aircraftspruce.com/catalog/topages/flaringtools4.php

I wound up buying an Imperial 437-FB tool today. It's a few cuts above the cheaper ones, but still not as fancy as some of the more expensive kits. It does have some features I like, such as a flaring cone press assembly that's easy to center on the tubing, and "stacked" dies which clamp lengthwise rather than across the width. Maybe I'll do a write-up on it when it comes!