You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
WTB-64 Vette rear axle tool
- Thread starter groucho
- Start date
Azmotorhead
Member
- Joined
- Feb 11, 2010
- Messages
- 23
Groucho I don't know if you're a member over at www.Corvetteforums.com
try there. I have one but unless you're local I don't loan tools.
You can get a new one from Corvette Central too
try there. I have one but unless you're local I don't loan tools.
You can get a new one from Corvette Central too
Yes, I'm on there. I don't need one right away...but feel it's time to add one to my box. I'd like to service my rear brngs soon on my 64. Hopefully I'll find a deal on one before I need it if I start searching now. ThanksGroucho I don't know if you're a member over at www.Corvetteforums.com
try there. I have one but unless you're local I don't loan tools.
You can get a new one from Corvette Central too
Lump
Well-known member
Hmmm. I have a few old Kent Moore tools left over from an old Chevrolet dealership in KY, from about that vintage. Do you know the part number? I could check my small remaining pile for you.
I don't know a number. But, I think the tool is a bit more recent and a basic slide hammer bolted to the lug studs was used for a long time before the tool came around. But, I can't swear to itHmmm. I have a few old Kent Moore tools left over from an old Chevrolet dealership in KY, from about that vintage. Do you know the part number? I could check my small remaining pile for you.