powerwagoncrazy
Member
As the title says. Trying to complete a set- looking for decent finish, owners marks OK. Thanks!
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
WTB Snap-On VS5226 13/16" 4-way angle wrench
- Thread starter powerwagoncrazy
- Start date
Delray
Well-known member
Hi:
I don't have an extra 13/16 but if you may need I have a 15/16 SVS30 with no marks and hard to tell from new for $35 a 5/8 SVS20 in the same condition for $25 and an older VS20 underlined mark with initials on one end but otherwise nice clean used for $15. If you have any interest I can post pictures and figure shipping.
Thanks, Larry
I don't have an extra 13/16 but if you may need I have a 15/16 SVS30 with no marks and hard to tell from new for $35 a 5/8 SVS20 in the same condition for $25 and an older VS20 underlined mark with initials on one end but otherwise nice clean used for $15. If you have any interest I can post pictures and figure shipping.
Thanks, Larry
OP
powerwagoncrazy
Member
Hey Larry- thank you very much for the reply! For the moment I'm really just after the VS5226 to complete my set, but down the road aways I might shoot you a PM about them. Thanks again!
OP
powerwagoncrazy
Member
Still searching!
OP
powerwagoncrazy
Member
Anybody?!? Been checking pawnshops, craigslist, and epay religiously (to no avail). Surely somebodys got a spare one in a drawer somewhere!