WTB - Williams engineer's wrenches

[Packard V8]

These would be the big, old clunkers, "one-ended" versions, open end, box end or square.

I picked up three in a box of junk and would like some others if available at a very reasonable price. Will offer to trade other USA wrenches 3-1 for these Williams.

thnx, jack vines

 

[OldToolMan]

JACK, I have some listed on my web also have an industrial finish #BW-8 1 1/4 looks new i can send a pic if you send your email.also have a #707 1 1/8"Armstrong looks just like Williams.

 

[LoneGunman]

Jack, if you run across any doubles I'm looking for them also, they don't have to be Williams.

 

[Cliff McNeill]

Jack I know I have some will take a look see for ya.

 

[Cliff McNeill]

Shoot! I thought I had a whole passel of 'em but must have traded/sold them. I do have one No 6A with the logo shown and a couple of smaller ones with different logos but still Williams. They arent beauty queens though. The 6A isnt too bad though. You are welcome to them for the cost of shipping.

I have a few from other makers. I will keep my eyes open for you.

 

[Packard V8]

Hi, Cliff,

Can't beat a deal like that. I'll look for Bluepoint X-series Box Wrenches for you.

thnx, jack vines

 

[hickmlg09]

I found a couple of these at a pawn shop last time I went. Was debating about getting them. Now I should have. lol.

 

[DaMaN]

I have a Williams Superrench #1009 1-7/16" "one-ended" wrench.

Let me know if interested.

-David

 

[premierplayer]

1 5/16 Billings, if any of you are interested, PM me
http://www.garagejournal.com/forum/showpost.php?p=847364&postcount=1

 

[SCscoutguy]

Jack I don't know if you would be interested in these but I figured I would post them just the same. One is a Armstrong Industrial 5/8" 703 "Special" marked US on the other side and the other is a Bonney 11/16" 603. I got them in a tool box I bought this weekend.

 

[HankMurphy]

Jack, or Mr. Packard, do you need a 703 - 5/8" IIRC?

Edit: Found it.

It could use a day in Evaporust -- let me know if you'd like me to do that, or if you already have this one.

IIRC, Elroy had a thread on restoring one of these Williams wrenches, but double open ended if memory serves.

Best regards,

Hank Murphy

 

[Packard V8]

I'd be interested to compare the Armstrong and Bonney to the Williams to see if they are identical. Let me know what you want for them.

thnx, jack vines

 

[SCscoutguy]

I'd be interested to compare the Armstrong and Bonney to the Williams to see if they are identical. Let me know what you want for them.

thnx, jack vines

If you have any craftsman combination metric wrenches under 13mm or over 16mm I am in need of quite a few.

 

[warmpancakes]

are you still looking for these?

 

[OldToolMan]

i found a Armstrong 1 5/8" looks just like the Williams.$8. plus ship

 

[OldToolMan]

the size is not 1 5/8" but 1 1/8" sorry for the mistake Larry