Just bought an older cp air hammer. The screw type retainer that it came with I cannot get most of my bits through, I guess since this gun was meant for air riveting. The specs on the retainer section are 1-1/8" wide on the outside of the threads with 1/8" thread spacing. Does anyone know where I could get a quick change retainer for it?
CP air hammer quick change retainer
- Thread starter Wesley B
- Start date
I see a lot of descriptions that say "fits most 0.401 shank air hammers" ,but that doesn't really tell me much.
https://www.amazon.com/dp/B00K4UDIR8/?tag=atomicindus08-20
https://www.amazon.com/dp/B000OUX9B8/?tag=atomicindus08-20
https://www.amazon.com/dp/B00K4UDIR8/?tag=atomicindus08-20
https://www.amazon.com/dp/B000OUX9B8/?tag=atomicindus08-20
Yes, that would be great. How do you like the gun?
I like it. I use it at home for DIY projects so I don't know how it would be in an all day long pro environment, but it sure seems like it would hold up. Trigger control is awesome.
The spring works good for holding bits and I can change them out pretty quickly by pressing up on the little lever on the right side of the attached pictures.
The spring retainer was less than $3 so that was also nice.
The spring works good for holding bits and I can change them out pretty quickly by pressing up on the little lever on the right side of the attached pictures.
The spring retainer was less than $3 so that was also nice.
