To avoid these ads, REGISTER NOW!

Gifo's Garage V3.0 20x11

iwantspeed

Well-known member
Joined
Aug 7, 2010
Messages
61
Location
Socal
To avoid these ads, REGISTER NOW!
OP
I

iwantspeed

Well-known member
Joined
Aug 7, 2010
Messages
61
Location
Socal
I needed to organize my hand tools and plier drawer

I put the tools i use the most in this drawer
i removed some stuff i had in a miscellaneous drawer and put the over flow from the plier drawer into the miscellaneous drawer.

overflowing drawer
Tool organization by ALEXANDER RENGIFO, on Flickr


cutting out patterns into cardboard
Tool organization by ALEXANDER RENGIFO, on Flickr

random scrap i found near the dumpster at work. it was on old pin board
wood back with a nice grey cloth glued to it.
Tool organization by ALEXANDER RENGIFO, on Flickr

cut to size with my pocket knife.
Tool organization by ALEXANDER RENGIFO, on Flickr

and done
Tool organization by ALEXANDER RENGIFO, on Flickr
 
OP
I

iwantspeed

Well-known member
Joined
Aug 7, 2010
Messages
61
Location
Socal

Ronin22

Well-known member
Joined
Oct 2, 2018
Messages
478
Location
BA
I remember your white E30 from r3v I believe?
It was a really cool build thread =) What happened to it?

Curious to see what you do with this one, and this garage. Cheers!
 
To avoid these ads, REGISTER NOW!
OP
I

iwantspeed

Well-known member
Joined
Aug 7, 2010
Messages
61
Location
Socal
im just driving my e30 and putting miles on it.

doing some maintenance on the e30.

timing belt
tensioner
water pump
spark plugs
air filter
fuel filter
fuel lines
oil cooler lines
oil pan gasket

Untitled by ALEXANDER RENGIFO, on Flickr

i drilled out the oil pan drain plug and used a time cert.
Untitled by ALEXANDER RENGIFO, on Flickr


Untitled by ALEXANDER RENGIFO, on Flickr


converted the stock oil cooler lines to AN lines. and had a shop braze on an fittings to the bmw hardlines
Untitled by ALEXANDER RENGIFO, on Flickr


i tidied up the wiring later on.
i was mocking up the oil cooler lines in this picture to get the oil filter to point at the ground but didnt like how close the hoses where to exhaust manifold. so i rotated the housing back to the stock orientation


Untitled by ALEXANDER RENGIFO, on Flickr
 
To avoid these ads, REGISTER NOW!
Top Bottom