Recent content by 17dodgebros

is there a good source of 1/2" id sandblast hose for a pressue blaster?

how close can I run a t vertical vent to a weather head? I cant find any info on this

the motor went bad on my kobalt 80 gal 5 hp compressor. I found a replacement motor but its not reversible. I need to know which direction the motor runs looking at the pulley.

i have a question about wiring my static phase converter.i see to connect l-1 and l-2 to the lugs on the converter,were do i connect the ground from the breaker panel and the machine? do i connect them together or to the converter box?

its a series 1,2j head

crank handle,graduated dial,table bracket

thanks,had it sitting in middle of shop my brother slid into it with truck. he feels like ****. was trying to do me a favor.

anyone know a good source for used brideport parts? i bumped my mill over and broke some parts. any help would be appreciated

anyone know who would haul a bridgeport mill from clevland to pittsburgh. just trying to figure out a cost for this

im looking for a bridgeport mill. must be in decent condition. also needs to use r8 collets