Recent content by 32chevy

I acquired an small industrial type ultrasonic cleaner and work like to know if it is feasibly or even possibly to repair myself. the unit shorted out after the heating element hardware vibrated loose and the elements dropped to the bottom of the tank. some of the wires to the signal receiving...

Thanks! I bought the generic Woodward fab roller and I stiffened it up with 3/8 thick plate and plan on buying a motor kit for 400 but if I can do this for under 150 with similar control then I’m gonna have a go at it while I still work at a machine shop

I will be starting a build thread if anyone is interested

Can you give us an update on the motorized bead roller? It’s been 5 yrs

I’m got to imagine a rubber seal could be cast from a custom machine die or maybe they exist that can replace these leather seals.

Looks identical to my Scott-atwater floor jack. I stopped rebuilding it because there was a leather ram seal that I didn’t know where I could buy. Or how to make

Hey all, it’s tough finding info on these. I would love a copy of a manual too. I bought one for 50$ and am stripping and painting it

Most vintage drill presses share that size. Delta, and buffalo have that size. Just research on ebay for drill press columns or tables . Most sellers give this info in the title. Be prepared to spend up to 200$

I dumped the water from the resevoir and cleaned it as best as I could . The access panel is small. Next I loosed the side plated, remove pins/linkage in order to remove the jack handle. After that I pounded on the jack plate to free the pivot point up. It took a while but I was able to free the...

I picked up this floor jack last weekend for $10. The jack clearly was left outside for many years. The front wheel studs are pitted and the rear caster is half rotted away. The jack is seized up, and water was in the reservoir. I gonna have at it. I can’t find much about this brand or model,

I just bought the miller 211 for 1000$ I’m excited to use it, says it will do up to 3/8”