Recent content by 47WDXPW

It could be the fire rating while under 5/8" of fire rated sheet rock. Some fire rated walls are double 5/8" rock.

This is for a commercial type building where one has much more floor space.

Someone is going to get hurt from a car lift collapsing using the advise being given here. Many here dont understand how a 3/4" wedge anchor works. Many dont believe the instruction given with a fastener is worthy of following.

There is a poly sheet vapor barrier under the slab pour but no insulation. I did a suggested vapor test of the floor by taping all 4 sides of a sheet of poly to the floor and look for signs of vapor after 24 hours, there was no signs after 3 weeks. The building sits high on all 4 sides and is...

Spider Dave, google retro fitting insulation in a metal building Im doing it now and am purchasing the simple Saver system you cut slits in the already installed insulation install R19 then use their covering and straps to hold it all in place the ceiling is sealed from their barrier covering.

30X48 steel building that was built with 2" blanket insulation installed on the roof only during the build and no insulation on the walls and no thermal break innstalled between the outside sheet metal and the gurts. Im in the process of installing R19 fiberglass with craft paper face in the...

Thanks

When a garage is insulated and kept above dew point is ventilation needed ?

The bubble is a tent of sorts for storing a car its set up inside a garage and the air from inside the garage is blown through the car "tent"

I was at large car show this weekend and a guy was selling what looked like a very well engineered car bubble system PVC plastic with a small blower the same as used on fair sized computer no heat was added and air flow was constant air flow leaking a pre determined amount through the zippers...

I have a 1500sf uninsulated metal building, concrete floor, that is very well sealed to air flow and is not currently heated as its used for car and parts storage would a properly sized dehumidifier be any better than adding heat for dealing with dew point humidity in the space ?

This is a SUN distributor machine ford flathead distributor adapter for mounting a flathead distributor in a SUN distributor machine for calibrating its in very good condition $175 [email protected]

I currently have 220 single phase in my garage and I would like to install a lathe that needs 220 volt 3 phase that will support a 3hp motor its a small precision tool room lathe that wont see use like anything it was designed for. In searching for a converter I have found static flat panel...

Where would I find the set up to do this correctly ? I take ownership of not paying attention to these details when it was installed but there are some slippery contractors out there.