Recent content by 56Chevy

They must have had some complaints about the previous version of the ramps. These are the new ones

Thanks for the reply. I was really thinking about the 36" ramps. The photo is great so I know what to do when I get them

Looking at the aluminum ramps but wonder about whether to do 36" or 48". I don't have any lowered cars

Found this one here. Looks very similar. It's an OTC 8100

Was watching an episode of Chasing Classic Cars and they used a cannister connected to an air compressor to syphon old gas from the gas tank. Has anyone ever seen such a tool

didn't see an FH model. This is the one I was considering M.TXBH Bench Motor with Square Drive

Looking at buying a Foredom Rotary Flex shaft. Looking to grind off tack weld on exhaust muffler where a die grinder is to large to access. Will this tool work? I could later use it for polishing, deburring etc.

Just looking to do upper wall cabinets so dents I don't think are an issue. As far as weight, shipping charges to get them here and I have to hang them. Like the looks of Moduline for not that much more money

Anyone using aluminum cabinets in the garage? Do they hold a lot of weight without shelves bending like particle board shelves. Looked at baldhead steel cabinets but are they heavy. Any brand better than the other?