Recent content by ace_cobra101

Hello, I have a 16' garage door, and it appears that the bottom panel is bowed in a bit, so the middle sits on the concrete before the outsides do, leavings gaps on the outside edges. Is there any way to unbow the panel. It has the metal struts on it. It is an insulated metal door.

Your right mygarageone, i SHOULDNT be doing my research first...Lord help anyone who has a question to reconfirm

Hi, what is the proper size fitting that goes into the back of the 50,000 Big Maxx units? I beleive 1/2inch, but any particular thread type? POL, MIF, etc?

anybody have any pictures of their propane tank installation?

And what about the attachment for the propane tank itself?

Is there a specific name to the line? I need something flexible to withstand the vibrations

Ok ill look at home depot. I dont have a Menards here, but we have a 'Kents' and 'home depot'. So far havent had any luck. What is the size thread to mate into the unit

HI all, Im installing a big maxx 50,000 btu propane heater. I have the tanks, the copper pipe fitting and all. But I am having trouble finding the flexible yellow line at a supply store. Anyone able to help? Im in NS

Also, the manual mentions nothing about wire sizing.

Is the included one any good? Any advantages in getting a better one?

Has anyone used the Mr Heater Big Maxx thermostat that is included with it from Princess Auto? Is it any good. It looks like I need to get new wire for it, as I beleive it is 4 wires instead of 2. Any advantage to this?

got ya. So I can just cut a hole and install the flashing on top?

OK. What is with the 12345?

Hello, I just got and hung my 50,000btu big maxx heater. Im starting to put in the venting. I have the vent kit, I just have one question about penetrating through the attic. I have the wall thimble installed where it goes through the drywall ceiling, but is there anything that needs to be...

Thanks rtakeda, Ill give them a call again.