Recent content by admactanium

I don't see why he's necessarily need to be much higher than the skim coat if the gap is exactly the size of the tape? I had something similar in our Master Bath when the heat pump drain pan leaked in the ceiling. Just lay down some mud, place tape on top of mud and put a layer or two over the...

I just installed 3 of the Oak Ikea slabs in our playroom. I need to join them and then sand down the seams. Other than the fact that the thickness is slightly different from piece to piece, maybe 1/16", they're great. They have Birch and Oak options. I've bought both in the past but these Oak...

Yup. My brother in law had a really fancy expensive stud finder when we started remodeling his house. Ended up using my Franklin model after a week.

I have a small project coming up with a stained concrete floor in a kitchen that I can do before and after shots.

I'd like to be included as well. Thanks.

I have a great Porter-Cable screwdriver and impact driver set I got for less than $150 if I recall correctly.

I haven't personally had good experiences with LED Track lighting if it's the kind that replaces mini-halogen bulbs. I had a bunch in my last house and the LEDs were really dim. If you're talking about a regular recessed light, I've replaced all the incandescent and CFLs in our new house with...

Bagster is a great deal if you don't have any other reasonable means to get rid of that stuff. My county dump is reasonably close but I don't have a vehicle that could reasonably handle all that junk. I put a bunch of stuff in one at my old house when I was redoing the drywall.

Not sure you'd even need to go to all that trouble. A can of spray mount and a trip to the CostCo photo center will give you a nice looking image to lay on top of it. With vinyl I suspect that the underlying holes would create easily visible indentations on the surface. Maybe that's not a bad...

Seems like attaching the whole laminate to the pegboard then drilling from the back of the pegboard through the laminate into a sacrificial board is the best way to prevent tear out and alignment issues.

Mitch, if you need a graphic designer to tune up your logo for you just give me a shout. I've gotten enough entertainment out of this thread that it warrants some pay back.

Yup. No reason tape has to be at 90 degrees.

Re: Tape Measures: Your go to? Plus one to that. Hard to find a good replacement for the old lever lock style.

Family handyman magazine has an active and knowledgable forum.

As a Graphic Designer I have to give you kudos for that. Great design and I'd buy a shirt of that for sure.