Recent content by Aroberson77

Something like this? Maybe I get some box fans and hang them from the ceiling...

Where I work at does stamping and molding, our tool room has a Torit unit for all the grinders and it works great.

I am actually still working on the compressor wiring, welder circuit is done. I definitely will be rereading the install manual and motor nameplate

Thank you guys for that info. I incorrectly assumed that the compressor was going to pull less amps than my welder

I like the downdraft table idea with a box fan. my grinding is not done on a bench grinder, but with flapwheels

I run a 50 amp breaker and 6 GA wire for my welder and am currently wiring a 40 amp with 8 GA wire for my air compressor. The idea is I could also run a smaller welder on the 40 amp circuit if I am doing sheet metal mig work. Both outlets will have 50 amp plugs.

Thank you for the info, I figured a wood dust collector would not work. I guess it will be a respirator until I can pick up a Torit

I do a lot of metal work, cutting and grinding and now plasma cutting, handheld and eventually CNC. What are some recommendations for metal dust collection. I do not want to spend $1000+ on a Torit or Grizzly system. Would the cheaper 1 hp or 2hp dust collectors meant for wood working work...

It's cool in a video but I bet it ***** to work in. I think a 20x20 is about as small as you want to go.

I have a craftsman taiwan breaker bar and it does well. I broke a HF bar at the square drive point, suspect it was a bad casting, my replacement hasnt broken Sent from my SM-G920V using Tapatalk

I have the bauer brand and used the old coupon to get it for $59. It worked good on the one panel I polished, It is not super well balanced, hands will definitely get a work out! Sent from my SM-G920V using Tapatalk

He said he didnt want that extra stuff. I was in the same boat, the CK 4 series is what you need for a stubby gas lens for a 17 series torch btw. Sent from my SM-G920V using Tapatalk

Just glancing quickly, you may have to add a radius equal to or greater than the diameter of the endpoint otherwise its tring to program a sharp corner Sent from my SM-G920V using Tapatalk

Really cool project, let me know if you have solid modeling questions. I havent used a lot of autodesk, but solidworks has good extensions for CAM Sent from my SM-G920V using Tapatalk

I am in NC and have a similar issue, but with attached 2 car garage. My walls arent dripping but my floor is soaked and car is soaked too. I think going from 20 to 60 deg in a few days has a lot to do with it, but I am gonna check to see how my garage is ventilated as well Sent from my...