Recent content by atxjax

  1. A

    Receommend some Long Nose External Snap Ring pliers.

    https://www.amazon.com/External-Straight-Retaining-Circlip-Removal/dp/B07MTRF2PF/ref=sr_1_50?keywords=external+snap+ring&qid=1566576585&s=gateway&sr=8-50#customerReviews
  2. A

    Receommend some Long Nose External Snap Ring pliers.

    Thanks for the advice. The bore dept is right at 2.125 inches. I have a set of KD pliers with interchangeable tips that usually gets everything done but since this bore is deep and those pliers are thick, it wont reach inside. easily. I recently stumbled across this on Amazon with a reviewer...
  3. A

    Receommend some Long Nose External Snap Ring pliers.

    Yes. They are circlips with the ears and little holes. I think straight long nose pliers would work best.
  4. A

    Receommend some Long Nose External Snap Ring pliers.

    I need to remove a field coil from a car a/c compressor. Need to purchase some long nose external snap ring pliers. What have you guys used that were good?
  5. A

    Replacement 5/16 shank tips for impact screwdriver?

    Been looking around the web and I have yet to find a good source for replacement bits for my impact screwdriver. Broke my last bit trying to get off some rotor screws on a Honda Pilot. Bits I need are 5/15 shanks # 2 and #3's. Anyone have a good place where i can buy?
  6. A

    Plomb tool picture thread - show your stuff!

    new guy here. Joined the forum after I had seen lots of good info on tools. This weekend I snapped the head off of my 1/2" breaker bar from Lowes that was 10 years old. It was a USA made one and they gave me Taiwan replacement. I bought this on ebay for $20.
See more
Top Bottom