Recent content by Benderbt

Looking to patch some rough spots in the garage floor. Bad spots are about an inch deep in worst places. Anybody had any luck using the concrete repair products sold in stores or have any other ideas. Not looking to tear the whole floor up or anything and it doesn't need to be perfect. Thanks

Im looking at doing the same thing... though i would post a pretty good deal but not sure on quality or what your looking for http://www.ebay.com/itm/Grade-5-Hex-Head-Bolts-Nuts-Washers-Coarse-Thread-SAE-Assortment-1270pcs-/151465916263?pt=LH_DefaultDomain_0&hash=item2344127767

30 amp double pole

The disconnect will be a double pole switch in the box that the wires are in now... would it be better to just wire up the switch and leave off?

Just added a sub panel in my garage. About ready to have inspector come. When I filed for my permit I included the circuit for my 5000w heater. I ran the 10awg wires in conduit and installed the breaker but dont have the money to buy the heater right at the moment. Is the inspector going to...

if i just run the ground out the bottom of panel and then make a 90 right out the wall will the inspector ding me on the 1 inch of exposed ground in the garage?

Thank you Charles. I have a 100 amp QO panel and I do not see this. There is a couple of small knock outs on bottom and sides of panels but this would require the ground wire to be exposed in garage for about 3 inches until it enters the wall. Would this pass inspection? Could i just drill...

I live in Iowa in the united states. The garage is detached.

I recently installed osb and insulated my garage. I am in the process of installing sub panel that is surface mounted to osb. The 4 wire feeder is coming though wall with outside lb. My question is what is the NEC approved method to get the bare ground wire out of the panel and through the...

The circuit does have a shared neutral but will be changed soon. Thanks

I have six 4 bulb T8 light fixtures in my garage on a new install. Once in awhile when I turn the switch off all the lights will flash full brightness only once and then stay off. What could this be caused by?

Let me start by saying Im new to forum and Im not very experienced in carpentry. I recently decided i would insulate my 16x22 work shop. The rafters have me wondering what im going to do.. What i would like to do is add 2x6's on 24" centers about a foot about the top plate to increase my...