Recent content by Burning

Good call, i am planning to add heat/air so i will look into the foam insulation under the slab.

The contractor will be doing the shell only. I’ll be doing the electrical rough in, insulation and finished walls.

Hows it going, looking to see what i may be missing for this "Mechanic" garage. I have a couple of stipulations based on what my HOA allows: Max 32x32 Sized Cant have ridge higher than the house (luckily im on a walkout basement and house ridge is at 32' Has to have premium exterior I have had...

Are you 32 wide or 30 deep? I am in the process of trying to design my 30Wx32D with a 2 post as well. I will have the man door on the side and was thinking about custom ordering a 20' door if possible.

Im replacing all the wiring and the magnetic starter. Ill keep that in mind when i do order wire. I have thought about it, its just super big and i dont know where i would mount it given the space i have

Lol, i almost grabbed the matching air dryer too for 200 bucks! I hope the after-cooler helps with moisture, if it doesn't ill run a manifold on the wall behind the compressor. Thanks for the heads up on the oil! Yup, thats what I figured its the same circuit of as my welder, but i figure i...

I have a dedicated 50 AMP breaker already wired in with 6/3 ran.

So i guess i need to start researching on pullies then. Ill see if i can find a online spec book on the pump and see if there is certain characteristics i need to have in the oil. I was not planning on bolting the compressor to the floor regardless as i will be moving in the next 2-3 years...

Hello everyone, just recently picked up this 120 gallon champion air compressor. Supposedly was used to run the automotive division of a Walmart center. It has a 10 HP motor thatÂ’s three phase. I only paid 500 bucks for it. I wanted something to power a sand blasting cabinet, grinders, sanders...

I am self teaching myself, i can weld decent on 110v on my Hobart 140. I bought the AHP 201 in order to start learning to TIG. I really wanted to upgrade to a 220v since i recently upgraded power in my garage. Just didnt know if its worth it to upgrade to a unit like this or find a used Hobart...

I already have a AHP 201, and was thinking about upgrading my Hobart 140. Is this worth it for me to upgrade to the Lincoln unit or should i just go with the Hobart 210?

248221 Set of 2 100-Watt 6.5-in Round In-Ceiling Speaker Down to 17.49 as well.

You are the man, I got some catch basins for my yard, found 20 of them.

Looks like the only one in the US lol

I got it working. Pretty powerful little tool.