Recent content by campbell62

Hi, I have a Black & Decker 11/16" super-service valve refacer that I want to replace the valve grinding wheel but the wheel keeps turning as I try to loosen the center allen bolt (which is tight!!). Is there a way to lock the wheel to get the bolt loose? thanks

Hi, would anyone happen to have a manual for Griot's engine analyzer #23310? I know this is a longshot.. thanks

Thanks Dave, time for dumb questions: drain what? where is the oiler and what kind of oil? thanks!!

Hi, I have a Hunter tc3250 in my home garage.. it works well however I don't have an operating manual for it. I think I should do some type of regular maintenance on it but have no idea what should be done - can anyone provide some guidence? thanks!

Hi, I just picked up a B&D Valve Face grinder (as well as a Souix seat grinder) with all the accessories. The unit has been sitting a while and I would like to lube it in the half dozen ports it has. Couple questions, what kind of lube? and the ports are small circles with a ball bearing in the...

yes, that one looks good! thanks

Just to clarify, the wires in the conduit: 2 of the 12 ga wires are used for a 110/20amp outlet, the others go to a separate 220/20amp outlet.

The 220 receptacle is about 60' from the box. The conduit has 5 #12's in it - the other wires are for a 110 receptacle. I was looking at those welders simply trying to determine how powerful a welder I could run on this circuit.. I was looking to buy used and you don't see many used inverter units.

I have been looking at the Hobart stickmate 205 ac and tombstone Lincoln 225.. but they called for 40 or 50amp input and I thought I could only go 30amp with the 12ga wire. I have read here that I could use a higher circuit breaker but didn't understand what was safe. thanks

I am confused with what I can safely do to wire up for a welder. My garage has a 220 receptacle with 12ga THHN 90c wire. This will be a dedicated welding line. Question is, what size circuit breaker should I run? how do I determine how big a stick welder I can use? thanks!

I was looking at it yesterday and what I thought was just a big bolt was a sight glass with a red dot in the middle of it - I assume that is the fill mark. I put 16 ounces of oil in and made it halfway there, I will need to get another bottle to make it all the way. thanks

Hi, I have a Energair 1, 60 gal 5hp compressor - but no manual. Would anyone know what the compressor oil capacity is? nothing is stamped on the compressor. thanks

Thanks!

Thanks for the leads, I have Panasport for racing wheels that slope on the inside, I am hoping new pads will help hold them.

Wow you have a nice looking (clean!) machine, mine is more of a road warrior. I have bought new pads off ebay but am looking for the accessory rp6-1485 the piece that holds down conical wheels by screwing in the center post. I have some conical wheels that keep raising up as I try to push the...