Recent content by Chuck79

  1. C

    The VISES of Garage Journal

    I posted photos of the vise = post #74947
  2. C

    The VISES of Garage Journal

    Thanks, While I was out in my Willys I was approached by a lady who said she had a pull behind field plow for an old Jeep she was looking to move out of her basement. I gave her my info and she sent photos and her husband's cell #. Long story short, for the price of the 1948 plow they also...
  3. C

    The VISES of Garage Journal

    Found this 85lbs International Nutyp Tool Corporation 60 41/2 vise while I was picking up a few other items. Looks in good shape, figure the year between 1930-1935.
  4. C

    Could use some help idenifying this vise

    I may have mistakenly posted this in a vise picture thread, hopefully this is the correct place for replies. Could use some help dating and identifying this vise. Doing a search here I believe it's a Reed vise. No markings besides 413, and jaw size 4 1/2" weighs 70lbs It would be helpful to...
  5. C

    The VISES of Garage Journal

    Could use some help IDing this vise. Doing a search I believe it's a Reed vise. No marking besides 413, and jaw size 4 1/2" weighs 70lbs It would be helpful to know the year made and manufacturer.
  6. C

    Garage door seal replacement

    In my case they wrapped the weatherstrip under the bracket.
  7. C

    Garage door seal replacement

    Thanks for the reply.
  8. C

    Garage door seal replacement

    I just replaced the bottom P seal on 2 of my standard size garage doors, just a straight forward replacement. My 14x14 door has 2 metal plates on each lower corner that holds a wheel and cable. The cables have tension, the cable, and bracket on one side needs to be removed to slide on the P...
  9. C

    BendPak: uneven lift arms

    Glad I could help. :beer:
  10. C

    The VISES of Garage Journal

    Thanks for the info :beer:
  11. C

    The VISES of Garage Journal

    Thanks for the info, good to know, when I have the opportunity I'll post as you asked.
  12. C

    The VISES of Garage Journal

    Thanks drivesitfar, I'll check out Carla's thread when I have more time, scanning through it quickly looks like a good read. So the Reed 214 R I own is a wood working vise? At first glance I haven't found a build day.
  13. C

    The VISES of Garage Journal

    Reed 214 R sheet metal vise Simplex
  14. C

    Compression - Show Off Your Compressor

    I replaced the springs and the plates (upper right corner) it was the only thing that came with the valve kit I ordered. Everything else I refurbished, purchased the retaining rings local. The head was packed with steel mesh from the oil bath filter. I chose to make a tool from an old...
  15. C

    Compression - Show Off Your Compressor

    Thanks, it's surprisingly quiet and runs good. The compressor was given to me and I have around $150 into it.
See more
Top Bottom