cmandp's latest activity

Those are common thicknesses of feeler guages

Yeah I have fround i dont like my Komelon tape either. It slowly creeps closed when doing flat work and the rounded shape falls over...

I think there are certain situations they can make things easier but I don't use them very often and have never tried them for...

Thanks no worries response was more about the comments from the detractors.

@cgrutt I was in support of you working on just those parts and not just replacing the whole compressor and recharging the system. What...

I'll be honest, my experience with A/C systems on cars is this: Once something goes wrong that you lose the factory charge, it has to be...

It says in the instructions to use secondary supports like jack stands. But I've never seen them used with stands in videos or...

I threw out an (admittedly cheaper) LED table light that melted the charge board somehow. I really wanted to use it to practice...

I am really considering a set of quick jacks but the lack of serviceablity and how susceptible they are to the pivots rusting is a bit...

When i think machinist level i think of 0.0005" per foot.

Do you think it would loosen up a quick jack?

I agree trying to open it more is probably making the issue worse. Any misalignment of the pivot axes (there are four of them) in...

I'd be frustrated at this point with these. I'd probably put a nice block of wood over each joint and hit it with my 8# sledge...

We are going to need to have you mess up a water line and shoot video of the repair now. You owe it to us

To add an alternative theory: Could it be that somehow you got these ramps to go way past their usual range of motion? Could parts that...