Recent content by Corybens11

I have a post frame building that I will be finishing the interior with ribbed steel. i will be wiring the shop with romex so my panel needs to be flush mount. Any ideas, advise, pictures? I was thinking of mounting it to a 2x4 in the wall and then surrounding it by a removable sheet of plywood...

What is your light layout? And are they 100w or 150w

So Im working on my light plan and I’m having a hard time deciding. I originally wanted to do led t8 strips but them started looking at high bays. I talked with hyperlite aNDL they did a work up for me but As you will see in the pictures and where my lift will be (at the 10” pads) I worry about...

I don’t want much slope. I’d rather have to push it to the drain than have a big slope

Hey guys. I’m in the final stages of planning my concrete for my 40x40 this year. I’ll post my plans here. Pretty simple. Trench drain, pads for two post lift, flat area for a future loft. Any advice, changes, etc.

I think i want to do one on each door either parallel or perpendicular. Hard choice. Wil it be ok to drive over with a skid steer

Do people normally slope the entire shop towards the drain or could I do the entire shop flat except near the drain

I’m trying to figure out my layout for my new shop so I can pour concrete this spring. It’s 40x40 and I’m planning on putting a lift in as shown. It will be used for auto repair storage and light fab/wood working. I’m trying to figure out how I should pitch the floors and where to put the...

i want the 12 foot door for the lift so i can fit cube vans and dump bed trucks in for the lift

very nice shop!

Ok thanks. Anyone have any pictures?

Looks nice! Rok_hunter

I’m looking at doing a 40x40x14 post frame this year with a 12x12 and 10x10 doors. I’m looking for tips, advise, and pictures! I want to be able to visualize the space. I’m going to use it for auto repair/work shop and storage for my toys. What I’m think for the main wall is a service door...