Recent content by cwrandolph

Currently building a 24' X 30' detached garage and need some advice on heating it. Here are some specs for the garage: - 2x6 construction, wrapped and insulated - 12' ceiling with insulation between upper & lower levels. - Storage trusses will allow about 6' clearance at peak in upper level -...

It doesn’t look like the ground bar is mounted to the enclosure - it’s mounted to a plastic bracket. Hope these pics help. Let me know what you think.

I am planning to have a 100 amp sub panel in the new garage fed from the 200 amp main panel in my house. The neutral and ground bars are bonded in the main panel and whoever wired it has neutral and ground wires connected to both bars. The only open terminals that would accept the wires going to...

If you're thinking about coating your concrete floor, I highly recommend Legacy Industrial products and this gallon of primer will save you some money. I purchased a garage floor kit from Legacy Industrial and used only 2 of the 3 gallons of epoxy primer. This is the standard epoxy primer in...

bump to the top

Bump -

FYI My extra gallon of Legacy Standard Epoxy primer is for sale in the classifieds. Medium gray - never opened. I hope that it's OK to post this here - let me know if it's not.

I also have about 3.5 lbs of the 1/4" vinyl flake left over that I will sell at a reasonable price. It's Legacy's system #2 which contains gray, blue, black, white flakes. (see picture)

NEW PRICE - Legacy Industrial Standard Epoxy Primer/Coating This is a great deal! I need to get this off of my workbench. I recently purchased a garage floor kit from Legacy Industrial and used only 2 of the 3 gallons of epoxy primer. This is the standard epoxy primer in medium gray. Includes...

Hard to believe that I started this project about 9 months ago. First I rented a machine from Home Depot with the Diamabrush tool but it wouldn't touch the old coating on the floor. I ended up on my hands & knees with a 7' Diamabrush tool on a hand grinder. I finished removing the old coating...

I am getting ready to put down the Legacy Nohr-S pigmented kit. Weather in Ohio has been wet and I am struggling to find a dry stretch to clear my garage out to get it done. I thought about doing half the floor at a time but ruled that out. Now I am considering doing just the primer on one...

I started working on my garage floor last fall. It had an old epoxy coating which was more difficult to remove than I expected. Ended up using a Diamabrush tool on a 9" grinder. I got about 2/3 of the floor stripped before cold weather set in and I am finishing it up now. My question is about...

?????

I have a oval shaped low area (about 18" X 24" X 1/4" deep) that collects water if I wash a car inside or from rain/melting snow dripping from a car. Since I am working towards putting new coating on my garage floor I am considering filling this area. Originally I planned on leaving it alone...

First - I learned that the saw cuts are called contraction joints. I've always called them expansion joints. I haven't bought anything to fill them yet but I'm planning to go with "Legacy's Gel Crack Filler". This stuff is somewhat flexible so, hopefully, it won't crack as the floor expands &...