Recent content by dacalkins

I love these wafer lights (canless recessed lighting). Can these be used in a garage? Sounds like a dumb question but I was under the impression that the garage drywall was a fire barrier and these holes might violate code.

What is a good rule of thumb for foot-candles?

I have been searching for lighting for my 37x20 garage. I like these but the pricing is steep. What is the lumen per sqft recomendation? https://www.obsessedgarage.com/collections/lighting/products/cree-ls-series-linear-light-fixtures?variant=41811152568471

Approved by an Electrician:)

I have changed it get the shaft to spin clockwise

Thanks everyone for your help. This is what I have concluded from all of your input. I have also sent this over to an electrician for his concurrence

Please find the ID plate from my motor. Thanks for all your help

I'm using the KBMT 240 with the appropriate resistors. I specifically chose this motor & controller because that is what Mr Pete used on his drill press. Unfortunately for me he was rather vague on how to wire it up.

Sorry but This is all new to me. If I have a 110 outlet should I wire to low or hi voltage for the "F" wires?

I purchased a used Baldor CD 3475 DC motor to be used with a KB controls KBMD controller. The DC motor has 6 wires (not 3 that I'm used to) A1, A2, F1, F2, F3, F4. I will be attaching the A1 and A2 to the A+ and A- depending on CCW or CW of the motor shaft. However, I'm confused by the...

I'm looking for a 5/8 ID pulley for my Delta drill press. I'm upgrading the motor which requires a larger shaft. Ideally it would be identical except for the bore. Thanks David

Thanks guys, any idea on the year?

What makes a 14 delta drill press a 14?

I have one of these. I inherited it from my dad