Recent content by Dalez

Can anyone fill in the blanks on the blue jack? I can make out an Lu at the beginning and two L's at the end. For the life of me I can't get any hits on the name regardless of what letters I put in there.

I had wondered about the private sale bit because I have heard of tools and boxes being repossessed. Which means they have some type of lien or ownership in it. Probably will bite the bullet and keep paying it off. I can give him ideas but kids are not that hot on advice from parents anymore.

Pretty much just letting him deal with it, just wanted to get a realistic expectation of what he could sell it for and it's obviously not as much as he owes on it. I will mention getting in touch with Snapon.

All very good info. He is without a doubt underwater with this box. I will check out 1st state sales. Thanks for the advice.

He was getting too fed too much warranty flat rate work which only pays half the rate at the dealship. So he is now a truck driver.

Please move if in wrong area. My son is trying to sell this box. He is shooting for $9500 no luck so far not even low ballers. Any idea what price it might move at or where to advertise? Located in Deland, Florida. 95th Anniversary Edition Snap On Triple Bay With Hutch $9,500

Mine was just doing that the other day. I snipped the wires off at the connection on the sensors stripped fresh copper and reconnected. Works fine now.

Might have something to do with twisting the frame of the trailer.

My M12 angle die grinder shuts down and flashes when I work it too hard but will start right back up.

Thought about it once in awhile but didn't know there was a right way and a wrong way.

Nice. Trying to figure out what to use it for. Probably air tool storage. It does have a lot of storage but you need to be able to get to all four sides to utilize them. Thanks

Just curious about maker and purpose. Has what seems like a harder vinyl top and small angled shelves. Would be interested in what the storage was meant for. Also has pull type rings to latch and open. Thanks

I prefer the thumbnails since you can go from one to the next easily.

That's what it is 3baygarage. Why my father would have it in his old toolbox is anyones guess. Thanks all.

I could use a blind bearing puller but most of my bearings are 3/4 inch id. This is too big.