Recent content by damnesia

Not sure if this should be in the Lighting & Electrical forum but that seems to be for garage/shop wiring so I'll start here. I have a mill which has an electrical box attached to it. I'm trying to determine what the box is. I have a service disconnect with 4 wires coming in, the green wire...

That might be the ticket right there, I'll look for one of those too. I have noticed that Williams did make a 3/4 single box end wrench which is another option, the 804a. Another option would be the Williams 8148 "Duohex-Box" 3/4 Single-Offset Box Wrench but actually finding one might be a...

I'm looking for a preferably vintage 3/4" offset box end Williams spud wrench. I can live without it being offset. I can't find one in any decent usa brand. Anyone seen one, do they exist?

I wouldn't pay it but that vise would go for a lot more than 100$ because of the hydraulic option. I've seen a few for sale recently-ish and they were about in the same condition. On Craigslist they were sold within hours of the ad being posted. Prices ranged between 400$ and 800$. I personally...

The Red Seal vise is awesome, very well built. I haven't taken it apart yet but there appears to be a spring on the lead screw and I'm wondering if it was put there by the manufacturer because this vise has seen very little use and probably hasn't been taken apart since new. This was part of a...

Just got this home. It's my first American Scale vise, actually the first one I've seen in person. Seems to be a well made vise. 4" No. 63 American Scale Red Seal.

You'll need to post pictures.

The same thing happened to me over the weekend. Made an arrangement to pick up the vises the same day and then there is radio silence all day. The guy gets back to me telling me he sold the Wilton for more than he was asking on CL but still had the other vise for sale, but the price was higher...

PMs sent.

That hood is bad ***.

I doubt I'll spend to much time on it, except cleaning the top and rewiring it. More than likely replace the bearings in the motor, although it runs well. Basically just clean it up and let it sit until I need it. Slowly pick up parts on ebay unless someone here has them. I rarely build things...

I'm trying to figure out who made this pipe vise. Anyone know what the M mark signifies?

Picked this up for 20$ yesterday, to replace my cheap ***, aluminum delta table saw. I'll buy just about anything with engine turning decoration on it :D Came with the original stand too. A 10" made by King Seeley, with a 1HP working motor. The speed handle on one of the knobs is missing and the...

Those vises are awesome. I love them but very rarely see them for sale.

That is a nice vise. I love Prentiss vises. Thanks for sharing.