Recent content by DamonM

  1. D

    Attic spray foam in tight edge corners

    Thanks for the input. I met with a spray foam contractor and agreed that it would be better to spray under the roof deck, the gables and the walls. The ceiling liner will be left off so they have good access.
  2. D

    Compressor outside during winter

    Thanks guys, I appreciate the feed back. I could put it in the garage but I also have a concrete bad along one side of the shop where I could build a closet for it.
  3. D

    Attic spray foam in tight edge corners

    My 24x24x10 shop is going up right now. The contractor is planning on putting in a ceiling liner unless I tell him otherwise. My plan is to insulate the walls with closed cell spray foam. My original thought for above was to spray foam under the osb roof deck. If I let my contractor put the...
  4. D

    10x10 door

    I purchased an insulated 10x10 door from my local Clopay dealer. Its a 9200 series door with R-18 insulation. Total cost delivered to my shop was about $950. My contractor should be finishing up on my shop this week with the door being installed on Thursday or Friday.
  5. D

    Wireless Thermostat

    I use this for my 4500 watt electric heater. It was easy to install and set up. Its not a thermostat but rather just an on/off 240 volt wireless switch. I can turn on and off the heater from the house using my phone...
  6. D

    About to buy lights from Amazon

    I bought a ten pack of Sunco lights from Amazon, 4000lm, 5000k. I've had them in my shop for four years and couldn't any happier. Bright, even lighting, no issues in cold weather, no noise on my fm radio. I'm currently building a larger shop and will get a few more without hesitation.
  7. D

    Compressor outside during winter

    I'm building a 24x24 shop right now and have been thinking about a new compressor but am concerned about noise inside the shop. My garage is ten feet from the shop and I thought maybe I could put the compressor in the garage and run a line in a trench to the shop. For those of you that have your...
  8. D

    New 24x24x10 under construction, thinking about spray foam....

    Thanks guys. I hope to see some examples of their work. Hopefully I'll have this wrapped up before the end of August.
  9. D

    New 24x24x10 under construction, thinking about spray foam....

    Thanks guys. I'll check out the reviews and ask for references. I'll be sure to get a couple more quotes too.
  10. D

    New shop floor coming soon, sealing question

    I'm having a new woodworking shop being built, I'm in Spokane Washington. It is 24x24 and will have a 4" concrete pad. Under the concrete I will have 2" of foam board insulation and then a vapor barrier. After waiting the 28 days for the concrete to cure I would like to seal it, maybe with a...
  11. D

    New 24x24x10 under construction, thinking about spray foam....

    The contractor started on my 24' x 24' shop on Friday. It will have 10' walls and a pitch of 4:12. I'm in Spokane Washington. I plan on going with close cell foam insulation with 2" in the walls and gables, and 3" under the roof deck. I have two estimates, one from a large company and one from a...
Top Bottom