Recent content by danbuff

Since you are local, why not visit??

I purchased mine in 2016, from order to arrival was 10-1/2 weeks

make sure isnt a double setscrew.. one under the one you removed

Thats horrible.. :( Looks to me like the front lift arm snapped... Scarey

NO. Also, consider umbrella policy which covers extended liability. I had an incident years ago plowing a cousins driveway.. Long story short, Insurance agent said I was making myself much more vulnerable by accepting any payment for any 'service' rendered.

My lift has 2 independent locks, and I never walk under vehicles to release the locks. Also, gives me a chance to see both sides of the vehicle before I lower, in case I forgot about the stool, or whatever may be in the way when I lower..

Maybe for ringing the wheel? Or heft so it doesnt bounce around when dressing?

Dektite high temperature: https://www.amazon.com/dp/B005MZEOT6/?tag=atomicindus08-20 I used one on my Beacon Morris.. Dan

nice setup!! You'll have a lot of fun in there. Congratulations..

I agree! Made in USA too!!! http://www.pocketweez.com/

I installed a 60K Beacon Morris recently, in my 24x36 - 10 ft ceiling barn. Its insulated fairly well. The heater does a great job, and I don't feel that it cycles too much or too little.. Quiet motor also. Calculations called for 45k, but I wanted a higher CFM. Works fine for me.

Good one :) I imagine a whole list of concerns/considerations for temperatures that low.. Not only for doors, but plumbing, septic, etc..

Yes and yes

You were right.. Did at top and it worked.. I ground out frame material, so ok now.. Reminder: If its sticky at 32, it will be stuck at zero degrees :)

Went to the barn to get tool..man door lock tumbler turns freely to the point where the deadbolt should retract, but wont budge. afraid to bust key. It was binding a bit few days ago..Now stuck I suspect frost heave.. :( Any suggestions? No other easy way to get into barn.. :( Thanks Dan