Recent content by dave89iroc

agreed......the tuner may have used his standard 5.3 swap flash that includes reduced/eliminated torque management

my house was built in the 50s, had 2 prong outlets, however, there was a ground wire running to every box, I was lucky enough that the ground was still long enough, so I popped the outlets, unscrewed the ground wire from the box, wired in the 3 prong outlets, and all done

yes, but keep in mind most also have a resistance coil for aux heat when the outside temp drops low enough that the heat pump is ineffective

rayovac industrial

I personally like the cable release over the automatic any reason you prefer the auto?

Not even a sledge hammer blow, I can blow out most non reinforced jams(with deadbolt locked) with a solid backswing from my arm....granted, I'm a big guy, so not saying most people would be able to do the same, but I wouldn't need any tools to get in most houses, and I doubt it would take any...

look at page 22

well, depends on the lifts, but one thing about a 2 and a 4 post, is you can have 1 post of the 2 post fit between 2 posts of the 4 post

attic if not drasticly more in cost

question is, why is he doing a compression test every 3 weeks?

Farm sink

insurance will pay out on stupidity, negligence, etc.

Steel square tubbing in concrete, flush with ground, 4x4 fence posts w/breakaway feature(highway signs have holes drilled through them)

per the NEC, he is going to have to run a subpanel, as he would be running more than 1 feed to a detached structure