Recent content by David79z28

  1. D

    Indoor car wash at home?

    I spray my cars down outside to remove any large chunks of dirt then use Optimum No Rinse car wash inside. I don't have as much water inside that way. http://optimumcarcare.com/onrwns.php?li=2 Sometimes I will even knock the dirt off by using the rinse cycle at the local car wash then take it...
  2. D

    Did you tip your builder/crew?

    I can never find one that does the job on time or right the first time so it's a no for me!
  3. D

    WARNING-STAR/NCI Metal Buildings

    The holes were predrilled on mine. I know because Heartland didn't put screws in most of mine. They even cut the panels down and cut out door openings with a skill saw. This threw metal shavings on the paint. The shavings rusted and burned the paint. I would go after your installer, not the...
  4. D

    WARNING-STAR/NCI Metal Buildings

    I have the same problem with my building. It was built by Heartland Steel out if Tulsa, OK. I have had the manufacturer, two other builders and another manufacturer look at it. Everyone points the finger to Heartland. Good luck getting it fixed!!! It's taken over two years to get these issues...
  5. D

    What buffer to buy?

    +1 autogeek has a great forum and a great "How to section" as well...
  6. D

    What buffer to buy?

    I use two different buffers/polishers. A vector rotary for the compound and machine polish. A Porter Cable DA polisher for the swirl remover, glaze, sealer, and waxes.
  7. D

    Is it illegal for a hotel to do this?

    That picture also needs to go in the post your WTF picture thread. http://www.garagejournal.com/forum/showthread.php?t=56771&page=136
  8. D

    oil change

    I think I was around 11 or so. Around that same time I replaced an alternator. I was all cocky thinking I can do this. Pretty straight forward. However, when you don't disconnect the battery and accidently drop the alternator with the wires still connected, it can make contact with stuff that...
  9. D

    New Guy from Texas

    Hello from NE Texas. Sounds like a cool project for your son!!! Any pictures??
  10. D

    Hi from Arkansas

    Welcome David...
  11. D

    Newb form Dallas Ga.

    Welcome to the site. Cool looking project!!!
  12. D

    New Bum On the Block

    Welcome to the site!!!
  13. D

    building manufacturers and builders in SW MO

    Stay away from Heartland Steel Buildings out of Tulsa.... I have a customer in Freeburg that has used Behlen Metal Buildings.. They are using them again to build another building.
  14. D

    Help your neighbors.

    Very nice!! Great unexpected reward for an unselfish act.
  15. D

    Hello from Central Texas

    Welcome. Thanks for your service.
Top Bottom