Recent content by Deplorable

Perhaps one reason for not more love is lack of support? I emailed both Ballistix and Armorpoxy asking about using SC over concrete stain and neither replied…

I read how wonderful Ballistix is. Yet it doesn’t often get recommended. Why? I see way more epoxy and polyurea suggestions than Ballistix. Again, why?

Thank you. First one done. Worked perfect. Yes, I changed springs. These open it, hold it and lower it perfectly. Still need to make some minor adjustments, but it’s working…

Hi. I have 12 foot exterior walls with a vaulted ceiling to 17 feet at center. I want to cut my garage door tracks to follow roof pitch. I understand without exact angles no one can tell me exactly where and how much to cut off horizontal tracks to make it work, BUT… Ballpark, how much do you...

@Leevon @Armorpoxy ‘What’s the details? Several are waiting to hear what happened and how it can be prevented. Or go another route…

New 48x32 slab waiting for an indecisive owner to figure out next step. Need y’all’s insight please. Super smooth finish, as seen below. Plans for a two post lift (one day). Likely won’t be welding on it, but will be a hobbyist garage with typical maintenance and light mechanic work (axle...

So assuming this is a possible installation issue? How do I prevent that if I go with Ballistix?

Ugh. Ordered three days ago.

Was thinking about Hellfire from Legacy...

https://www.ecosafetyproducts.com/Eco-Etch-Pro-Concrete-Etcher-Cleaner-Concentrate-p/ee3-8000-1.htm

My slab was power troweled, but a small leaf ended up on the finish and you can see that it’s rough where the leaf was. I’m going to etch the floor. Will the leaf imprint still be visible? Should I try to patch it? I’m concerned I’ll make it worse by trying to fix it...

Need to prepare new slab for my coating. Does anyone have experience with Eco Etch? Floor is in great shape with no oil stains but was power troweled.

Can more than one tint pack be used to make it even darker? Wouldn’t go over board, but if two ounces is good, would four be better on the final coat if one wants a darker floor?

I am willing to prep. But unenthusiastic to grind. So what door does “a little prep” open for me?

I want something that requires minimal prep work, is easy to apply, very durable (light mechanic work, but have done axle swap and the like), long lasting and chemical resistant. And I have no idea what the best is! The more I read the more unsure I am... Decided on Rust Bullet DuraGrade...