Recent content by drewalt

Nice work area.

Also thinking of putting epoxy down with the in floor heat. Do some products work better/worse with in floor radiant?

Is there any downfalls to having two zones set up with one zone off for future use if needed? Any problems with corrosion or pumps going bad if that zone isn't used?

Well, I finally did it. Ended up with the Argo boiler. Pic attached.

Looking for a source to supply me a pump board kit for my in floor heat. I have two zone pex in my pole barn floor and need to get pretty much everything except the tubing: boiler, pumps, manifords, etc...... Anyone have some recommendations?

bump again

Has anybody used an Argo Electric boiler or compared the Seisco vs. Argo?

Thanks Steve and John. I will check out the Z strip and the roll up door. I will also have a man door on a different wall.

I thought about doing RH/LH custom door. Thought it would be easier just to buy one. Yes please post a pic of the Z frame.

Ceiling will be 8' in the work area. Standard door height and would like at least 72" width (opening). Steve, any idea where to find steal insulated pre-hung french doors (no glass). I asked a few places and they wanted $$$ and special order.

Just built a 40x64x14 barn and I am enclosing about 1000 sq ft of it for a heated workshop/office. I would like to have an entry from the cold storage area that I can bring snowmobiles, dirt bikes, atv's through. I was thinking of a set of wood french doors, but it seems that they are all...

Thanks for the link..

How many zones did you do? Any "rough" estimates on the cost?

Thank to all for a great site. I am getting ready to build a 40X64X14 pole barn in Michigan. It will have an enclosed 16X32X8 office/shop that will be heated during the winter. Currently no natural gas available and we have GEO w/electric backup for the home. I plan to my $$$ in...