Recent content by dunnsrun1

Thank you for the input, I will start looking at units...:thumbup:

Thank you for all of the input, I will do a heat loss calculation and go frm there. I am located in Southern Illinois. Next week I will be studding out the inside walls and applying spray foam insulation on the walls and roof deck. The shop is a 10' tall pole barn with metal siding and roof...

,,,,

I am almost finished building my new 50x50 work shop and am wondering what would be the best type of heating/ AC to use. Unfortunately I did not think to put pex in the slab when it was poured to radiant is out of the question. Would a 4 ton resendential type unit be my best bet with a single...

How about Rust Bullet, does anybody have experience with this product? It almost sounds too good to be true...

Here are the rough drawings of the floor plans...

This was a great link, very informative. Thanks

Trey T, This is exactly the type of input that I am looking for. Just to make sure that I am understanding you correctly, it seems that you are happy with the epoxy-coat except for the amount of time it took to receive the order, is that correct?

This thread has been a great tool for those of us trying to figure out if epoxy is the right product for us. You did a great job educating us on the amount of labor involved in the application process. Thanks for taking the time to post your project...

Here are a few pictures of the building in progress, if all goes well it will be finished in about 2 weeks:beer:

JCQick, I love the video, have you started erecting the building yet?

Thanks for all of the information guys it is truly appreciated... what I am hoping for now is some feedback from members of the forum that have used these products. It would be great to know how the products are holding up after a few years of wear and tear along with installation victories or...

hdepoxy, I am having trouble finding out exactly what your products are on your website. how does your Nohr-s Polyurea compare to a 100% epoxy system or are they the same thing?

Thank you for the information

Armorpoxy, I just had the floor poured last week, do I still need to have it diamond grinded before applying your product? Also, what is recommended for the relief cuts in the concrete...