Recent content by Ebaby35

The foot switch was plugged into wall and the power cab that came out of my dc controller plugged into the foot cord. Doesn't smell burnt

Well now I need to have the dc controller looked at or figure out if I broke it. I took all the wire and connections off and now the led light doesn't even turn on and immediately after plugging in it trips my breaker. So not sure if my dumb *** destroyed it.

Just want a switch that give whole unit power. Then a switch to toggle forward and reverse and knob to set speed. And a foot paddle that when machine is powered when pressed will go in whatever direction and speed I have preset. Maybe I got the wrong foot pedal because I first plug it into...

Ok so somehow I blew my fuse. But you guys have be a lot of help. These are all the things I need to have wired. I have a on/off switch, a potentiometer for adjusting,) speed, a forward/brake/reverse switch and a momentary foot pedal which plug into wall and then the power cord from dc converter...

Sorry to sound dumb but what is the zigzag line in the diagram with the 5k ?

Quick question does the drum switch have to be run through the dc drive? Could I have it connected right before the motor and connect to to the power coming out from dc controller?

Going to try what Walt's suggested but without the light which isn't a must just thought it would look cool. Thanks for your help too

Thanks for the help I'll be trying this and let u know, I appreciate it.

Hi sorry I running a Dayton 4z723a gear motor 1/12 hp 90v dc motor with a kbmg-21d controller. So far I have a on/off switch, potentiometer connected and working. I would like to connect a forward/reverse drum switch and have this controlled to start when I press the foot pedal. I have a light...

Ok I'll got my bead roller almost all wired up, except for the momentary foot switch. Does the foot switch connect to dc control board? The foot switch I have can work by plugging it into the wall and the bead roller then plugging into it. So every time I press pedal the machine turns on and...

Ok Im stuck on what size or type dc speed controller to get. I have a Dayton dc 90v motor full load amp is 0.59 its model number 4z723A. I see listings for dc speed controls for like $300+. Im just not sure what to get or if I can get something that rated for over what I need. this is going to...

Got it off eBay it's 1/12hp 90v 525:1 torque 340

Its a 90v. So with a dc controller it will allow me to control speed?

I just bought a dc motor and want it to run on a foot pedal with variable speed control and forward and reverse. Do I still need a dc speed controller or just a foot pedal or both? just trying to be able to plug into wall and use. I wasl told that the dc speed controller would allow me to do this.

Thanks for your help the label on motor say amps .80