Recent content by ENG80TWR

My plan is to have the WH and pressure tank (I’m on well water) in that room with a sink so that I don’t have to heat the whole shop in the winter. Put a little wall heater in there set at 50 and let it go. My original plan was the top right corner of the drawing for the lift. That just makes me...

Yesir. 14 ft side walls. 14x14 roll up door. Ceiling height in the center is closer to 17 ft as it is a tubular metal building

no input on the lift ? or any other opinions on the layout ?

Put the downpayment down for sa 30x50x14 tube metal garage. Going to be starting the footers next week and I can't decide on where I want to put the lift. I am doing a 4-5" floor which is acceptable for the lifts I have looks at but I would like to go ahead and dig a little deeper in the area I...

Shot grade today on where my plan is to put the building. Im around 5 foot foot of fill needed for the back side of the shop if I go 50 deep. calculated with 25 loads of shale plus skid steer work and a sheep's foot roller im looking around 5700-6500 just for the pad. Leaning towards going 50...

Hello, I have been looking around on here for some time. Finally made an account so I could look at pictures and already gotten some good ideas. Im located in WV, have a decent chunk of land and no restrictions other than the wallet. Originally planned for a standard 30x40 pole barn but now...