exmaxima1's latest activity

If you are already using machined collars you don't need the circlips. The collars are way better. And with modern wheels you find...

Judging solely from the switch and your metric tape measure, I would say it's an Asian-made model that was sold in Australia or the EU...

Screwdrivers. regardless the quality, are consumables--they wear out. If you don't use them enough to wear them out, then any will do...

My first Civivi and I have to say, I'm impressed. This one is the Mini Shakan.

The notches in the rear of the jaws indicate it is a C-3 or C-4. The weight of an early C-3 is around 150lbs, so that is my guess

I like to dress my wheels with a single point diamond. It is faster than multipoint and leaves the grit open so no subsequent operation...

For $20, you did fine, especially since you didn't already have one. However, I would have merely cleaned it up and put it to use.

I've bought and sold a LOT of used bench grinders. My hypothesis based on years of field research is that all Grinding wheels must have...

You also need a vac pump

I've been using the diablo blades for a while. I have them on all my cutting saws (miter, table, circ). I wouldn't suggest cutting...

I just replaced the run capacitors for the second time, and added a "hard start" cap kit, so I think I will get a few more years out of...

Disston 20243 ? https://www.worthpoint.com/worthopedia/disston-combination-bench-drill-press-523644356

Thanks!

One more issue. My system is 3-ton and it honestly does the job though it runs quite a bit at times. The online calculators say I need 5...

My Lennox Elite 13 is now 26 years old and probably living on borrowed time. I'm looking into upgrading from the R22 system to a newer...