Recent content by eyeballengineer

  1. E

    Show your new tool arrivals

    Went to 2 inch. Wish they were full polished past 1 5/8. Some brass punches too
  2. E

    Milwaukee Toolboxes?

    For all those who say the quality is good. Compared to what? The drawer close was pretty neat but i have tinfoil thicker than what that box is made from.
  3. E

    Anyone have a Miller Spectrum 625 plasma cutter?

    so 2 for hypertherm?
  4. E

    Anyone have a Miller Spectrum 625 plasma cutter?

    Bring back old thread sorry. Our 6 month old spectrum 625 extreme that has been broken and repaired a few times aready, Board replaced, gun replaced, troubleshot to death by miller service. Broke again today. Cup fault after 30 to 60 seconds of cutting. Anybody know the secret to keeping...
  5. E

    25mm socket uses?

    12 point 20mm is the size of the large/ upper idler gear center bolt on dt466 engines. Never needed a 6 point 20, or 25mm yet
  6. E

    Reversible ratchet wrenches, expanding Snap On

    Have a Blackhawk set, made by proto in mm up to 35, or 36. they might make inch. they are holding up well though I don't use them a whole lot
  7. E

    Is there a cordless powertool equivalent to an air hammer?

    You can get tanks in aluminum, not as easy as a little lithium battery but a lot lighter than a compressor with the cfm to run a hammer. Not for everyday but tanks have helped me out in a pinch a time or 2. Ill have to do some looking for those little chisels. Thanks
  8. E

    Is there a cordless powertool equivalent to an air hammer?

    Dive tank, regulator, air hammer. easy. Another note what about a 1/3 or 1/4 power/ size air hammer for small more precision jobs?
  9. E

    who has a full socket set up and how is it organized?

    This was my second order, still may make another, this is the work box, some are for the home box. The cleared up a lot of space, 1/4 is in another drawer, will get some more pics tomorrow, organization is a never ending job in a tool box.
  10. E

    Who makes the best screwdriver bits?

    I've used SO forever in bit sockets, but noticed in the last couple years that my replacement/ warranty bits seem softer. I would rather have my bit shatter and break under stress than twist, fold and strip my fastener. Anybody else notice this?
  11. E

    CAT Tools

    my price from work is $412, cat employee price is $370ish, list is $515. SO list is $730
  12. E

    CAT Tools

    Bringing back an old thread, sorry I was looking thru the CAT hand tools catalogue today, thanks to GJ, and found a full set of 30/60 offset wrenches from 3/8 to 1 1/8 CAT part 1p-3515. Matches almost exactly SO part number vs814a, but almost half the price my cost. Can anybody confirm they are...
  13. E

    Let's see your toolbox.

    Who makes the box? I like the tall hutch.
  14. E

    I've HAD IT with Creepers!

    That's the CM version of the snappy I use. The DOT inspector we use always has a new cheap Craftsman every time he comes down, says the particle board there made of falls apart the first time they get a little wet. He just keeps buying them cause there cheap and he always has a new one. Works...
  15. E

    what are these tools?

    the socket with the split looks just like one I have for wing nuts. Handy for putting up shutters
See more
Top Bottom